Note:
1) Press the Menu/Enter button to activate the OSD window.
2) Press ▲ or ▼ to navigate through the functions. (Press “▲” key: the item will
move to the forward item; Press “▼” key: the item will move to the next item), (Once
the desired function is highlighted, press the Menu/Enter button to activate it. If the
function selected has a sub-menu, press ▲ or ▼ again to navigate through the
sub-menu functions. Once the desired function is highlighted, press Menu/Enter
button to activate it.
3) Press ▲ or ▼ to change the settings of the selected function. To exit and save,
select the Exit function. If you want to adjust any other function, repeat steps 2~3.
4) When AC off / on , and then press menu key , menu item will always in “Picture”
page, it needn’t to save when AC off.
5) First press Power button will show OSD, and press the second time will power off
(*1):When Image Ratio is set to 4：3，and than set picture boost on，frame position
should change to picture start.
Wide 4：3
(*2): Language order please refer to VESA MCCS spec.
15
To Next Page
Loading...
