EasyManua.ls Logo

GTPro VC 320 - Safety Instructions

GTPro VC 320
9 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6
VC 320/321
Original operating manual
1Safety instructions
Warning! Read and observe all information and safety instructions.
Ignoring warn-
ing notes and instructions may lead to electric shocks, fires and/or cause serious injury.
Keep all safety information and other instructions in a safe place for future reference.
This machine can be operated by
children
over 8 years of age and persons with re-
duced physical, sensory or mental capabilities or a lack of practical experience and
knowledge, provided they are supervised or have been instructed to use the ma-
chine safely and understand the dangers of machine operation.
Children
must not
play with the machine.
Cleaning and user maintenance
may not be performed by
children
without supervision.
Risk of explosion and fire hazard: do not extract
sparks or hot dust, flammable or
explosive dust (e.g. magnesium, aluminium, petrol, thinner, with the exception of
wood), aggressive fluids/solids (e.g. acid, leach, solvent).
Observe all national safety regulations as well as the material manufacturer's spec-
ifications!
Not suitable for extracting hazardous dust.
Always use suitable protective equipment!
If intact following a visual inspection, work in a dry environment according to in-
structions!
If foam or fluid starts to escape, switch off the machine immediately.
Clean the fill level sensors
[7]
and inspect for damage at regular intervals.
Not suitable for extracting fluids that foam excessively.
Always operate with the filter system installed.
Always use the socket on the machine for the purpose specified!
Check the plug and the cable regularly and should either become damaged, in order
to avoid a hazard, have them replaced by an authorised after-sales service workshop.
Do not lift or transport using a crane hook or lifting gear!
Only for AS/NZS:
The tool shall always be supplied via residual current device with
a rated residual current of 30 mA or less.