E-7E-6
INSTALLING/REMOVING COMBINATION FILTER
2. Press the Lock & Release
Button and remove the
Rear Cover from the unit.
3. Remove the used
Combination Filter (Filter C)
and dispose of it in
the garbage.
5. Insert filter system into the unit.
Consult the arrow on the filter
for correct installation direction.
6. Reattach the Rear Cover of the unit and securely latch into place.
1. Turn off and unplug the unit.
4. Before inserting new filter, connect two filter pieces
together. Be sure the white, pleated side of each
filter piece is facing the same direction, then slide
the plastic tabs together and lock filter pieces in
place. Your new combination filter is now ready to
be inserted into air purifier.
Digital Air Cleaning System
Improve your indoor air quality with your new germguardian
®
Air Cleaning
System. Multiple levels of cleaning include a combination True HEPA filter
that captures allergens, and Charcoal filter to remove odors. UV-C light
technology enhances germ-killing.
Pre-Filter*
Captures initial dust and allergen particles.
Charcoal Filter* (aka Activated Carbon)
Charcoal/Activated Carbon contributes to the control and prevention of the growth of
bacteria, germs and mold.
Pet Pure
TM
True HEPA Filter
True HEPA captures 99.97% of allergens. Pet Pure Treatment inhibits the growth of mold,
mildew and odor-causing bacteria on the surface of the filter.
UV-C Light
UV-C light technology works with Titanium Dioxide (TiO
2
) to enhance the elimination of
airborne germs. TiO
2
is activated by the UV-C light to decompose remaining odor molecules
caused by smoking, cooking and pets.
*Pre-Filter and Charcoal Filter are combined into one layer that attaches to the HEPA Filter.
AIR CLEANING LAYERS
Main Unit
UV-C
Bulb
UV-C
Metal
Shield
Combination
Filter C
includes Pre,
Charcoal & PetPure
T
M
True HEPA filters
Rear Cover
with Air Inlet Grill
Lock & Release
Button
The Air Cleaner will beep for 30 seconds and the HEPA reset light will flash continuously
indicating that is is time to replace your filter. Replace the filter according to directions
then insert pen tip into HEPA Reset area on control panel to restart the system. Depending
on usage, filter will last approximately 6 months.
To Next Page
Loading...
