Gude GAK 1000 B User Manual (English)

Other manuals for Gude GAK 1000 B

Questions and Answers:

B
Brandon BellAug 10, 2025
How to start a Gude GAK 1000 B when the engine won't start?
- C
  Cynthia ForbesAug 10, 2025
  If your Gude Saw's engine isn't starting, there are several possible causes and solutions: * The tank might be empty. If so, refill the tank. * The spark plug could be dirty. Try cleaning or replacing it. * The operating switch might be in the “OFF“ position. Ensure it is switched to the “ON“ position. * The carburetor may need cleaning, or you may need to contact a customer service center. * The spark plug could be wet; in this case, dry the spark plug. * The ignition cable could be defective, requiring assistance from a professional or service center.
W
weavernatalieAug 16, 2025
What to do if the chain on my Gude GAK 1000 B Saw is not being supplied with oil?
- D
  Dana SmithAug 16, 2025
  If the chain on your Gude Saw isn't getting oil, the oil tank is likely empty. Refill the oil tank to resolve this issue.
M
mariagibsonAug 22, 2025
Why is my Gude GAK 1000 B only cutting when pressing on it intensively, and only a small amount of sawdust is produced?
- C
  Christine PowellAug 22, 2025
  If your Gude Saw cuts only when you apply intensive pressure and produces minimal sawdust, the chain is probably blunt. Sharpen or replace the saw chain to restore proper cutting performance.
B
Brian JacobsAug 28, 2025
What to do if the chain keeps getting released from the chain rail on my Gude Saw?
- C
  Carrie MeyerAug 28, 2025
  If the chain keeps coming off the chain rail of your Gude Saw, it could be due to a couple of reasons: * The chain might be too loose. * The rail and chain may be fitted wrongly. You should tighten the chain.
L
Lauren JenningsSep 3, 2025
Why is oil dropping from my Gude Saw?
- R
  Robert HolmesSep 3, 2025
  If oil is dripping from your Gude Saw, the oil cap is likely not closed properly. Make sure to tighten the oil cap.