Operation
Step-b
y step Instructions
1. Hang the counte
r pulley (pic. 1/8) hook (pic. 1/7), which the rope (pic. 1/9) is attached to, safely on the load drawn.
2. Push the stretching spring (5)
to the slackening position (up), thus releasing the interlock (4).
3. Rope ma
y be unwound if the detention lever (2) is held in the release position. Hold the detent lever (2) pressed and pull the
stretching pulley to the other spot of hanging!
Caution: Travel 1,3 m max. (#38350) 1,4 m max. (#38351)
4. Push the stretching spring (5) to t
he tensioning position (down), the interlock will thus snap (4) in the pulley.
5.
Now, pump the lever with a stretch-slackening spanner. The rope will gat wound on the pulley again and the load is drawn in th
e
required position.
6. Push the stretching spring (5) to the slackening position (up), thus releasing the interlock (4). If the interlock is unblocked, the
load carrying hooks may be removed again.
Attention! The load could break away suddenly.
Caution: On a slope, the load should be secured against slipping!
Troubles – Causes – Troubleshooting
Trou
ble
Cause
Trou
bleshooting
Retaining pawl will not unblock
1. Broken spring 1. Replace the spring
Stretch-straightening spanner does not work
1. Broken spring 1. Replace the spring
10
To Next Page
Loading...
