11
7. OVERLOAD PROTECTION
If the tool insert becomes caught or jammed, the drive to the drill spindle is interrupted.
Because of the forces that occur, always hold the power tool firmly with both hands and
provide for a secure stance.
Operating Instructions
Reduce the pressure on the drill bit when it is about to break through. This will prevent
the drill from jamming.
When drilling a large hole, first drill a pilot hole using a smaller drill bit.
Always apply pressure to your drill bit in a straight line, and if possible at right angles to
the workpiece.
Never change the operating mode whilst the rotary hammer is running.
Do not apply excessive pressure to the tool when chiseling. Expressive force does not
speed up the work.
Working Hints For Your Rotary Hammer
To Next Page
Loading...