Customer Helpline 0333 3201989
10
5. SPRAYING TECHNIQUES
To obtain the best results, keep your spray gun level and parallel to the surface at all times.
Keep the nozzle 5~15cm from the surface and spray evenly from side to side or up and
down, use smooth and even strokes (See Fig. G1).
NOTE:
• Make sure that you have masked the areas that should not be sprayed by a good quality
masking tape.
• The intended area to be sprayed should be pretreated to be smooth and clean, free from
dust.
• Before operating, aim the spray gun at a piece of scrap material and start spraying to
find the best pattern and flow rate.
Do not spray as showing in Fig. G2.
Operating Instructions
G1
G3
G2
5-15cm
11
10
To Next Page
Loading...
