Customer Helpline0333 3201989
9
3� VARIABLE SPEED CONTROL
Adjust the thumb-wheel to increase or decrease the speed (SEE FIG C) according to the
material, material thickness and blade specification to be used (also possible during no
load operation). See Chart 1 for general guidance on speed selection.
Avoid prolonged use at very low speed as this may damage your jigsaw’s motor.
Chart 1
Material Speed setting
Wood 5-6
Metal 3-4
Aluminum 3-5
PVC 3-4
Ceramic 3-5
Operating Instructions
To Next Page
Loading...
