EasyManua.ls Logo

Guldmann GH3 Quick Guide

Guldmann GH3
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
The ceiling hoist is switched on by pressing
one of the buttons on the hand control unit.
The green light will indicate that the hoist is
ready for use.
If the indicator light shows yellow after 15
seconds, this means that the hoist power
supply is not connected.
If the indicator lamp is yellow and the hoist
is beeping when activated, there is a fault on
the hoist.
If the hoist does not switch on, this may
be because the emergency stop has been
activated.
The hoist does not need to be turned off – it
switches off automatically after approximately
two minutes without activation.
The hoist recharges when it is in the rail sys-
tem or when the hand control unit is placed
in the charging station – irrespective of hoist
model. Recharging will always take place
irrespective of the height of the lifting hanger.
The hoist’s lifting capacity is marked on the
hoist, e.g., 200 kg /440 lbs. Note that the rail
system or the sling may have a lower lifting
capacity. The lowest lifting capacity must not
be exceeded.
If you have any questions regarding instruc-
tions and training, ask your environmental
health & safety coordinator, human resources
manager or your line manager.
Quick Guide – GH3

Other manuals for Guldmann GH3

Question and Answer IconNeed help?

Do you have a question about the Guldmann GH3 and is the answer not in the manual?

Guldmann GH3 Specifications

General IconGeneral
Power Supply24 V DC
Emergency StopYes
Lifting Capacity300 kg
Safe Working Load (SWL)300 kg
Lifting Speed30 mm/s
Emergency LoweringYes
Duty Cycle10% at maximum load (2 minutes on/18 minutes off)

Related product manuals