Operation &
Maintenance
Manual
A6ML0066 – Euroblast SF Instruction Manual
7.1.10.6 Replacing the HEPA14 Filter Cartridge, C800 Dust Collector
A secondary HEPA filter has been added to ensure maximum air filtration, minimising the amount of
air born particles exhausted by the system. The health of this filter is checked by using the
magnehelic manometer gauge fitted to the side of the machine. This measures the differential
pressure across the main filters. When the pressure difference reaches 2.5” Water Gauge then a filter
change will be necessary.
1. Undo the M6 Hex Screws from the filter lid and
remove.
2. Replace with a new HEPA filter (Y1CA0064)
ensuring that the air flow arrow on the filter match
those on the inner frame.
3. Carefully lift the HEPA panel filter from the frame
and remove.
4. Replace the filter lid and tighten the M6 Hex
screws.
To Next Page
Loading...
