Guyson 2 - Page 52

Operation &
Maintenance
Manual
Issue:
10
A6ML0066 – Euroblast SF Instruction Manual
Date:
05/2019
Page: 52
7.2.1 Hopper elbow
Hopper elbows will either be made of PU or Mild Steel. If they are Mild Steel they will either have a
PU or Mild Steel Wear plate fitted depending on the specification ordered. The wear plate should be
inspected and replaced when worn thin. If the elbow is made of PU and has worn through then a new
hopper elbow will be required.
7.2.1.1 Replacing the wear plate
 Turn dust collector on
 Turn cyclone on
 Run machine for 10 minutes to clear pipes
 Turn cyclone off
 Turn dust collector off
 Detach hopper elbow
 Replace wear plate
 Reattach hopper elbow
Item code
Description
E1AA0097
90° Ø100 PU Hopper elbow
E1AA3176
Wear plate side loader hopper elbow
If your elbow is not one of those listed in the table above then please contact Guyson International for
more information.