EasyManua.ls Logo

GVA DD1-10 - Page 8

GVA DD1-10
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3
Locate the bar freezer:
Away from direct sunlight, which may aect the acrylic coating.
Away from sources of heat (stove, heater, radiator, dishwasher, etc.),which may increase
power consumption.
In an area without extreme cold ambient temperatures, which may aect cooling
performance.
In a cool, well ventilated area, without excessive moisture and high humidity.
Installing the unit in the coolest area of the room will save energy consumption and
running costs.
To ensure correct operation, this appliance must not be located where the temperature
will be below 10°C or above 43°C.
Ensure there are no obstructions that could prevent the freezer door from closing.
To level the bar freezer, adjust the levelling legs at the bottom of the unit.
The refrigerator must have at least 50mm clearance between the rear of the appliance and
the wall, 100mm between the sides and wall, and the space above the top should be at
least 100mm. Ensure that there is enough spacing to open the door to 160°.
Before plugging in your new bar freezer, let it stand upright for approximately 2
hours. This will allow the refrigerant gases to settle into the compressor and reduce the
possibility of a malfunction in the cooling system from handling during transportation.
The Bar Freezer is suitable for connection to 220-240VAC 50Hz supply. The Bar Freezer must
be plugged into a dedicated individual 220-240VAC main socket outlet.
Plug the unit into an exclusive, properly installed and earthed wall outlet. Do not under
any circumstances cut or remove the third (ground) prong from the power cord. If in doubt
about your setup, direct any questions concerning power and/or grounding to a certied
electrician.
Do not use an extension cord or an adapter plug.
Secure the bar freezers supply cord behind the unit. Do not leave it exposed or dangling to
prevent injury and accidental disconnection from the power supply.
NOTE: After plugging the appliance into a wall outlet, allow the unit to cool down for two
to 3 hours before placing food in the refrigerator compartment.
Getting Started (Cont.)

Related product manuals