8
Instructions
Starting up
• Connect the DVD Player to your TV (or amplier, if desired) as illustrated on
page 5.
• Switch on your TV set and select AV mode.
• Plug the DVD Player into an appropriate power point and switch on power to
the outlet.
• Press the POWER button on the front of the unit or press the POWER
button on the remote control of your DVD Player. The screen will display
“LOADING” if a disc is loaded, or “No Disc” if no disc is loaded.
• Press the OPEN/CLOSE button on the front panel of the DVD Player, the tray
will come out automatically.
• Place a disc on the tray and press the OPEN/CLOSE button to close the tray.
• After using the unit, press the POWER button on the remote control to switch
the unit into standby mode.
Functions
• Unless indicated otherwise, use the remote control to operate the functions
described throughout this manual.
• All functions can be accessed/operated with the remote control buttons, some
can also be accessed from the front panel of the DVD Player. The function of the
remote control buttons is the same as the corresponding buttons on the front
panel of the DVD Player.
• See the following pages for detailed information about these functions.
To Next Page