University of Portland - p. 1 of 3 - Function Generator - GFG-8219A.docx
Function Generator Tutorial
Gw Instek GFG-8219A and GFG-8216A
The function generator is used to generate signals for testing circuits. This tutorial describes how
to set up the function generator for basic signals such as sine, triangle, or square waves.
Getting Started
Turn the Power button on. Make sure that the Duty, CMOS, Offset knob and AMPL knobs are
all pushed in. On the GFG-8219A, also make sure that the Frequency knob is pushed in.
Connect a coax cable to the BNC connector labeled Output.
To Next Page
