GW Instek SFG-2107 User Manual

Artisan Technology Group is your source for quality
new and certied-used/pre-owned equipment
• FAST SHIPPING AND
DELIVERY
• TENS OF THOUSANDS OF
IN-STOCK ITEMS
• EQUIPMENT DEMOS
• HUNDREDS OF
MANUFACTURERS
SUPPORTED
• LEASING/MONTHLY
RENTALS
• ITAR CERTIFIED
SECURE ASSET SOLUTIONS
SERVICE CENTER REPAIRS
Experienced engineers and technicians on staff
at our full-service, in-house repair center
WE BUY USED EQUIPMENT
Sell your excess, underutilized, and idle used equipment
We also offer credit for buy-backs and trade-ins
www.artisantg.com/WeBuyEquipment
REMOTE INSPECTION
Remotely inspect equipment before purchasing with
our interactive website at www.instraview.com
LOOKING FOR MORE INFORMATION?
Visit us on the web at www.artisantg.com for more
information on price quotations, drivers, technical
specications, manuals, and documentation
Contact us: (888) 88-SOURCE | sales@artisantg.com | www.artisantg.com
SM
View
Instra

GW Instek SFG-2107 Specifications

General

Output Impedance	50 Ω
Frequency Resolution	1 μHz
Arbitrary Waveform Length	16 k points
Arbitrary Waveform Resolution	14 bits
Frequency Sweep	Linear, Logarithmic
Weight	2.5 kg
Output Waveforms	Sine, Square, Triangle, Ramp, Noise
Modulation	AM, FM, PM
Power Source	AC 100V - 240V, 50/60Hz
Harmonic Distortion	≤0.5%
Display	3.5 inch TFT LCD
Frequency Range	1μHz to 7MHz

Summary

SAFETY INSTRUCTIONS

Safety Symbols

Explains safety symbols used in the manual and on the device.

Safety Guidelines

Provides essential safety rules for operating and storing the SFG-2000 series.

GETTING STARTED

Panel Introduction

Device Setup and Power-Up

Guides through setting up the device, including tilt stand and powering it on.

SINE/SQUARE/TRIANGLE WAVE

Set Duty Cycle (Square Wave)

Procedure for setting the duty cycle for square waveforms.

Set Offset

TTL CMOS OUTPUT

Select Waveform

Set Frequency

Instructions for setting the frequency for TTL/CMOS output.

Set Duty Cycle

Procedure for setting the duty cycle for TTL/CMOS square waveforms.

Set Amplitude

How to set the output amplitude for TTL/CMOS signals.

SWEEP

Activate Sweep

Steps to enable the sweep function for waveform output.

Select Log/Lin Sweep

Set Sweep Time

Set Sweep Span

AMPLITUDE MODULATION

Activate AM

Steps to activate Amplitude Modulation for SFG-2100 series.

Set AM Depth

FREQUENCY MODULATION

Activate FM

Steps to activate Frequency Modulation for SFG-2100 series.

Set FM Deviation

COUNTER INPUT

Activate Counter

Steps to enable the counter function for SFG-2100 series.

Set Gate Time

APPENDIX

Error Messages

Specification

Technical specifications for the SFG-2000 series instruments.