How to switch speed modes:
Three riding modes:
3.LED Display and Riding Modes
Speed Mode
It has three speed modes.
Mode 1: Low speed, the limited speed is 6.2mph.
Mode 2: Medium speed,the limited speed is 12.4mph.
Mode 3: High speed, the limited speed is 18.6mph
How to switch speed modes:
Press the M button on the display to switch speed modes.
Three riding modes:
Mode 1:E-Bike
Mode 2:Pedal Assistant Bike
Mode 3:Bike
It is bike mode when power off. It is assistant mode when power
on, but assistance performs well just when the motor speed is
lower than manual speed, or perfomrs well when climbing, this
is normal. It is E-Bike mode when power on too, you do not need
manual pedalling.
4. Instructions for using Folding Pedals
Installation:
The pedal shaft core "L" and "R" correspond to the left and right
sides of the crank. The L shaft core requires counterclockwise
installation, and the R shaft needs to be installed clockwise. Use
a 15mm open-end wrench to tighten it. Ifthe crank is made of
aluminumalloy,the pedalshaftmustbe coatedwith threadglue
before it can be screwed into the crank.
2
Steps to install the foot pedal:
1.Take out the pedal, L is the left pedal, Risthe right pedal.
2. Align the crank threaded hole with the central axis of the pedal.
3. Use a wrench to clamp the central shaft of the pedal and
tighten it, turn the central shaft of the left pedal counterclockwise
and tighten the central shaft of the right pedal clockwise.
Use:
When the pedal needs to be folded, first stop the bicycle and push the
pedals 30mm inward with the palm of your hand, and then fold it up or
down to complete the folding. If you need to open it, push the pedal shell
out with your hands or feet to open it.
Note:
When the pedal needs to be folded, if you push the pedal shell inward with
your hands, do not grab your fingers on the pedal shell to prevent your fingers
from being caught and injured.
Foot pedal
To Next Page
Loading...