Parts List:
(1) Top shelf with handle
(1) Middle shelf with 8 leg bosses
(1) Bottom Shelf with caster inserts
and four bosses
(1) Electrical Assembly if 'E' model was
purchased
(4) 8 1/2" Legs
(8) 16 1/2" legs
(3) Cable Management Clips
(2) 4” Swivel casters with brake
(2) 4” swivel casters
WT16, WT26, WT34, WT42 & WT1642
Tuffy Cart Assembly Instructions
Rubber Mallet
Optional: metal hammer with
block of wood to cushion impact.
1. Place top shelf on firm surface, under-
side up. Insert legs onto leg bosses. Press
fit as much as possible with hands. Tap
firmly with rubber mallet if necessary.
For WT16, WT26 & WT34 use 8 ½" legs at
this time. For WT42, use 16½" legs at this
time.
2. If making a WT16 or WT26, your table
has no middle shelf, please proceed
to step 4. Otherwise, postition middle
shelf, underside up, onto legs. Press fit
as much as possible with hands. Using
rubber mallet, firmly seat legs into shelf.
3. FOR WT34 & WT42 ONLY - Place 16½"
legs onto leg bosses. Press fit as much as
possible with hands. Seat firmly with rubber
mallet.
4. Position bottom shelf, underside
up, onto legs. Firmly seat shelf onto
legs using rubber mallet.
Required Tools
(not included)
H. Wilson Company
2245 Delany Road
Waukegan, IL 60087
(800) 245-7224
sales@hwilson.com
Note: You may have extra
legs after assembly is finished,
depending on the height you
choose to make your cart.
TO MAKE A ASSEMBLED HEIGHT USE THESE LEGS USE THESE SHELVES
WT16 16 ½" 8 ½" TOP & BOTTOM
WT26 24 ½" 16 ½" TOP & BOTTOM
WT34 34" 1 SET 8 ½" & 16 ½" TOP, MIDDLE & BOTTOM
WT42 42 ½" 2 SETS OF 16 ½" TOP, MIDDLE & BOTTOM
5. Insert casters into caster sockets,
making sure that you have the two
locking casters in the caster sockets
on the 18" long side of the cart that
has the handle.
To attach the electrical assembly, please see
the instructions included with the assembly.
Updated 12/12/06
To Next Page
Need help?
General