What to do if Habasit Controller display is off?
If the display of your Habasit Controller is off, the fuses FU1 and/or FU3 might be blown, or the electronic card could be faulty. You should replace the fuses or order a new electronic card.
What to do if magnetothermal switch tripped or fuses broken in Habasit Controller?
If the magnetothermal switch has tripped or the fuses are broken in your Habasit Controller, reset the magnetothermal switch IMT1 and/or replace fuses FU1, FU2, and FU3. First, disconnect the equipment from the mains electricity supply. Then, unscrew the 6 side screws and remove the top cover. Identify the magnetothermal switch and fuse box using the photographs. Reset the switch or change the broken fuses. Finally, close the cover and tighten the screws.
What to do if indicator light L1 on Habasit Controller rear panel is off?
If the indicator light L1 on the rear panel of your Habasit Controller is off, it could be due to a tripped magnetothermal safety switch IMT1 at the auxiliary sockets. Check that the equipment is connected to the power sockets and reset the switch as described in the manual. Alternatively, in the version with a 3x400V supply without neutral, the indicator light L1 stays off and the two auxiliary sockets are unusable.
What to do if indicator light L2 on Habasit Controller rear panel is off?
If the indicator light L2 on the rear panel of your Habasit Controller is off, the safety fuse FU2 may be blown. Follow the replacement procedure in the manual to replace it.
What to do if Habasit Controller has no air?
If your Habasit Controller has no air, check that there is air in the supply line.
What to do if Habasit Controller has no current?
If your Habasit Controller has no current, check if the main switch is in the ON position.
Guidance on attaching and installing the regulating unit correctly.
Essential safety precautions and guidelines for operating the regulating unit.
Information on protective guards and safety devices fitted to the unit.
Details on the different operating modes of the regulating unit.
Guidelines and rules for the correct and safe use of the regulating unit.
Explanation of warning and safety signs affixed to the regulating unit.
Crucial safety warnings related to the operation and maintenance of the unit.
Information on any residual risks associated with the use of the regulating unit.
Required training and qualifications for personnel operating or maintaining the unit.
Settings for maintenance operations and system configuration.
Guidance on diagnosing and resolving common faults and issues.
List of alarm codes, their meanings, and recommended actions.
General| Brand | Habasit |
|---|---|
| Model | PMR-06 |
| Category | Controller |
| Language | English |
To Next Page