34
Lorenz Hasenbach GmbH u. Co. KG · D-65517 Bad Camberg · Tel. 0049 6434 / 25-0 · www.haca.com
Table of contents
1. General information
1.1 Safety
1.2 Checking and inspection
1.3 Care / servicing / maintenance
2. Use
3. Accessories
3.1 Fall arrest rails
3.2 End stops
3.3 Removal flaps
3.4 Identification plates
4. Labelling
5. Standards and regulations
5. Test centre
7. Documentation
8. Checklist
1. General information
The company operating this fall protection system must ensure that
these Instructions for Use are kept with the fall protection runner. The
fall protection runner including the fall arrest rail corresponds to EN 353-
1:2018. It is a sub-system which, when combined with a safety harness
in accordance with EN 361, is a fall protection system in accordance with
EN 363.
A vertical ladder must be equipped with fall protection starting from 3m
according to DIN EN ISO 14122 and starting from 5m according to DIN
18799. In case of a fall up to 6KN can be transferred to the physical struc-
ture via the guided type fall arrester and the rail.
Lorenz Hasenbach GmbH u. Co. KG · D-65517 Bad Camberg · Tel. 0049 6434 / 25-0 · www.haca.com
Please read before assembling!
Caution: incorrect use can lead to a risk of death!
Please contact our head office in Bad Camberg if
you have any queries regarding
To Next Page
Loading...