6
Problem
Power lamp of, unit doesn’t
work
No power supply
No water in water tank Fill up the water tank
Tighten the switchSecurity switch isn’t tight
New unit
Dirty water
Remove the water tank, open
the cover and let it stand in a
cool place for 12 hours.
Clean the water tank, ll it
with clear water
Connect power supply,
switch on.
Power lamp on, no mist
outlet
Abnormal smelling mist
Power lamp on, unit doesn’t
work
Reduced capacity
Abnormal noise
Mist fog coming out from
around the nozzle
There are apertures bet-
ween the nozzle and tank
Dip the nozzle in water for a
while and put it back in the
socket
Resonant in water tank due
to not enough water
Unit is on an unstable
surface
Fill the water tank with
water
Move the unit to stable at
surface
Too much scale in the water
tank
Water is too dirty or kept for
too long in the tank
Clean transducer
Clean water tank, change
water
Too much water in the
water tank
Pour out some water from
the water tank. Close the
water tank tightly.
Reason Solution
This marking indicates that this product should not be disposed with other household
wastes throughout the EU. To prevent possible harm to the environment or human health
from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of
material resources. To return your us device, please use the return and collection systems
or contact the retailer where the product was purchased. They can take this product for
environmental safe recycling.
To Next Page
Loading...