-
St'
IC
LU
temc
Mod
MODEL
PRODUCTION
avebni navod
dnotkou
U.
open na
nt.
nl/rnh
SUPER ZOOM
4D
-
TOP FLYER
je superakrobaticw model pro
4D
akrobaticke Ietani. Model je vyroben rnoderni
technologii na CNC strojich z
"nezniCitelneho" rnaterialu EPP. Model by1 naveen ve spolupraci s Davidem Kyjovswm.
Model je pohanl5n elektrornotorem
MEGA
RC 400/15/7R s vrtuli 10/4,7". Baterie 3 Clanky LiPol 730 mAh spolu s
pohonnou je
urnoZiiuji ziskat letovou vAhu rnodelu po
30
grami
!
Diky sve konstrukci je model schopen
Ietat
i
ve vgtr
Model je sch
pfil plynu viset na vrtuli a po plidani plynu lerer ~o~mo vzhfiru, je schopen zaletet looping
v
noiovem
a
vSechily ahludaticke prvky.
S
modelem mGie letat temgi kaidy a diky sve konstrukci a pouiitym materidlim je
8
nezniCitelny a vydrii
i
"neSetrn6" zachazen
i.
lel je dodavan ve tiech barevnych modifikacich.
uhych 4:
I
.".I
I
""122if6
j
zapoCetim prAce proCtete peelive stavebni nAvod. VSem ijkolQm vgnujte nAle2itou pozornost. Na pfesne praci
si
I
letove vlastnosti modelu. Pied lepenirn zkontrolujte v5echny dily zda spolu pfesne licuji. Pokud dily nesedi,
dvte je neb0 obruSte tak, aby piesne licovaly.
Budete potfebovat
4 kandlovou RC soupravu s
3
mikroservy, elektromotor MEGA RC 40011 517R No. HC3550D, regulator F18-3PH 18A
No.
HC3353, kuiel28 mm No. HC5320, vrtuli 10/4,7", baterii Lip01730 mAh 3 Cldnky, vteiinove lepidlo, aktivdtor, 5 min
epoxy.
instruction
guide
ER
ZOOM
4D
-
TOP
FLYER
is superaerobatic model for 4D aerobatic flying. Model is produced by modern
technology from EPP -"almost unbreakable" material. Design of SUPER ZOOM 4D is done by David Kyjovsky (Czech
champion in indoor aerobatic flying) on the base of his experiences in aerobatic competitons.
This model is powered with high performance brushless electromotor MEGA RC
400/15/7R, accus LiPol 3 cells 730
--
'-,
propeller 1014,7". The wingspan of the model is I000 mm and wing charge is only 18,5 g/ sqdm
.
Accu pack LiPol
mAh gives together with the power set the pull 600 g while the flying weight of the airplane is only 430 grams
!
You
ly also in the wind.
SUPER ZOOM 4D is able to "torque roll" and then after givina more "gas" to rise vertically up, looping in "knife" flight
and all aerobaticfigures.
Important
Please, read these instructions several times until you are fami~rar wl~n each step, before you begin to assembly. If the
parts will join, but with
a
gap, sand or trim the parts
a
little at a time until the parts exactly meet with no gaps.
Item!
4
Ch
contr
thin
s
Needed To Complete: (Not Included)
annel RC Set with 3 Micro Servos, brushless electrornotor
MEGA
FORCE 400/15/7R No.HC3550DI speed
'oller F18-3PH 18A No.HC3353, spinner
28
mm
No.HC5320, propeller 10/4,7", accupack Lip01730
mAh
3 cells,
ype cyanoacrylate glue, activator spray,
5
min epoxy.
Maximalni vjichvlkv kormidel
-
Pro zaletani doporuEujeme pouiit poloviEni v$chvlkv.
Maximum movements of the control surfaces
-
For the first flight are recommended half movements.
.
.