03.
ELECTRICAL SAFETY (continued)
• Only connect the product to a grounded outlet/line with the
voltage and protection as specified in the “Technical
specifications”. Have the grounding installation made by a
qualified electrician while using the product with or without a
transformer. Our company shall not be liable for any problems a
rising due to the product not being earthed in accordance with
the local regulations.
• Never wash the product by spreading or pouring water onto it!
There is the risk of electric shock!
• Never touch the plug with wet hands! Never unplug by pulling on
the cable, always pull out by holding the plug.
• The product must be disconnected during installation,
maintenance, cleaning and repairing procedures.
• If the power connection cable for the product is damaged, it must
be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
• The appliance must be installed so that it can be completely
disconnected from the mains supply.
• The separation must be provided by a switch built into the fixed
electrical installation, according to construction regulations.
• Rear surface of the oven gets hot when it is in use. Make sure
that the electrical connection does not contact the rear surface;
otherwise, connections can get damaged.
• Do not trap the mains cable between the oven door and frame
and do not route it over hot surfaces. Otherwise, cable insulation
may melt and cause fire as a result of short circuit.
• Any work on electrical equipment and systems should only be
carried out by authorised and qualified persons.
• In case of any damage, switch off the product and disconnect it
from the mains. To do this, turn off the fuse at home.
• Make sure that fuse rating is compatible with the product.
To Next Page
