200
IMPORTANT: each call button on the outdoor caller unit can be linked via radio with up to 4 handsets.
5.5 Creating the radio link between the handset and the controller
(1) These parameters can be modified at a later stage (see User manual/Modifying handset operating options/Modifying
options for use).
1. At this stage in the installation procedure, the handset should display:
If this is not the case, the handset needs to be charged (see chapter on
Charging the handset before installation) until the language selection message
is displayed.
2. Pick up the handset, open the cover and select the desired language (1) using
the following keys
then .
The handset beeps for 2 sec.
3. Programme the time (1):
A/ set the first digit using the keys
B/ set the next digit using the key .
C/ return to steps A and B to set the minutes and then, once the desired
time has been programmed, press .
The handset beeps for 2 sec.
4. The handset then moves on to radio link set-up mode and displays:
5. Pick up the handset, stand next to the controller and follow the procedure on the next page:
The key selects the previous character
IMPORTANT: after 2 minutes,
the handset exits radio link creation mode and displays:
Reprogramme the time (Step 3 in this chapter), then refer to the
procedure described in chapter “9.1.3 Specific cases, creating a radio
link between a handset and several controllers or several outdoor
caller unit call buttons” in order to create the radio link between the
controller and the handset.
To Next Page
Loading...
