hager Tebis TX 100 User Manual

21
Configuration or programming phase
Num.
What to do if...
13
No communication
between wire pro-
ducts and radio
products.
Solutions
14
A double press is
sometimes neces-
sary on an unidir
input under teles-
witch or variation
operation.
5
15
Input numbers not
selected are
displayed errati-
cally on TX100
screen.
20
Configuration or programming phase
Num. What to do if...
10
The icon
appears in the left
upper corner of
the screen.
Solutions
11
Links created bet-
ween RF products
fail.
5
12
The communica-
tion between radio
products is no lon-
ger operating.
- Avant toute chose, vérifier que le TX100 est en position ''auto'' (nécessaire pour un
fonctionnement normal)
- Check the wiring of products.
- Measure disturbances and transmission/reception powers while placing TX100 in
mode of measurement (see §13 page, §14 and §15 page 25 and 26 of TX100
Instructions).
- If no fault is detected, reconfigure the link between these products.
- If the problem remains, configure a bidir product as a repeater (see page 26 §16
TX100 Instructions) or install a repeater TR140 to increase the radio range of the
installation.
Note:
- the number associated with this symbol corresponds to the total number of incom-
plete or inconsistent remote loadings that have occurred at the time of installation
configuration
- this symbol will disappear after checking items 8 and 9.
' - Check that the tool TX100 is in AUTO mode.
- Make sure that the "auto/manu" switch of each modular product is in position “auto“
- Check the wiring of products (voltage presence on bus and mains supply).
- Check the programming of links.
- Check that the tool TX100 is in AUTO mode.
- Make sure that the "auto/manu" switch of each modular product is in position “auto”.
- Check the wiring of coupler.
- Redo coupler pairing (see Note No.2).
- If not replace the coupler (see Note No.22).
With unidir products this operation is normal.
Note: In order to avoid double pressing, perform the function with two
push-buttons: the first one configured as 'on' and the second
configured as 'off'.
- Check that nobody operates other push-buttons of the installation.
- Check that no wire or radio input transmits permanently at the time of installation
configuration (Presence detector, clock, input module to be radio embedded …):
check the Konnex traffic: see §15 page 26 of TX100 Instructions.
Note: To avoid this type of embarrassment, for the products of
modular input, it is advised to set the switch "auto/manu" to the
position "manu".

hager Tebis TX 100 Specifications

General

Brand	hager
Model	Tebis TX 100
Category	Control Unit
Language	English