EasyManua.ls Logo

Haier 55 Series - Wi-Fi Management and Technical Details; Wi-Fi Activation, Reset, and Control; Radio Module Technical Data

Haier 55 Series
195 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN 8
Wi-Fi Use
To activate the Wi-Fi, long press the Wi-Fi key for 2 seconds, the Wi-Fi icon will turn on and
an acoustic signal is made.
If the Wi-Fi has not been configured yet, when the refrigerator turns on, it will
automatically enter the configuration mode and keep this status for 30 minutes. To use
the configuration mode:
Press the Wi-Fi key for 2s, the refrigerator enters the Wi-Fi configuration mode
and an acoustic signal is made. The Wi-Fi icon starts blinking.
Follow in app instructions to configure the Wi-Fi (see above).
Once the Wi-Fi is configured and the connection established, the Wi-Fi icon is on
and fixed.
After 30 minutes without performing any operation, the Wi-Fi will automatically
exit the configuration mode.
If the Wi-Fi has already been configured, it will automatically reconnect
according to the configuration information.
To reset the Wi-Fi, long press the Wi-Fi key and Mode for 2s, the Wi-Fi is reset and an
acoustic signal is made. After this, the Wi-Fi will automatically enter the configuration state
(Wi-Fi icon will start blinking again).
To turn off the Wi-Fi, press the Wi-Fi key for 3s.
Radio equipment type is in compliance with Directive 2014/53/EU.
Frequency rate (OFR)
2400 MHz-2843.5 MHz
100 mW
2412...2472 MHz(step size 5 MHz)
Channel frequencies
Maximum power(EIRP)
Radio-module - Technical data

Table of Contents

Related product manuals