29
3. The stability can be checked by alternately bumping on the
diagonals. The slightly swaying should be the same in both
directions. Otherwise the frame can warp: possible leaking
door seals are the result. A low tendency to the rear
facilitates the closing of the door.
Fine tuning of the doors
If the doors are not in one level, this mismatch can be remedied
by following:
A) Using adjustable foot
Rotate the adjustable foot according to the direction of arrow
to turn up or down the foot.
B) Using spacers
► Open the upper door and lift it.
► Carefully clip the spacer (enclosed in the accessory bag) in
the white plastic ring of the middle hinge by hand or using
tools like pliers. Do not scratch or bruise the door.
In the future use of refrigerator, doors uneven phenomenon may occur to the weight of stored food.
Then please adjust according to the above methods.
Waiting time
To the maintenance free lubrication oil is located in the capsule
of the compressor
.
This oil can get through the closed pipe
system during slanting transport
.
Before connecting the
appliance to the power supply you have to wait 2
-
5 hours so
that the oil runs back into the capsule
.
Electrical connection
Before each connection check if:
► power supply, socket and fusing are appropriate to the rating plate.
► the power socket is earthed and no multi-plug or extension.
► the power plug and socket are strictly according.
Connect the plug to a properly installed household socket.
WARNING!
To avoid risks a damaged power cord must be replaced by the customer service (see warranty card).
To Next Page
Loading...
