Operation
Steri Clean Operation
◆Functional description:
the purpose of this function is to clean the evaporator.
◆Entry and exit：
If this function is needed, please select in the hOn APP.
◆ Note:
SELF-CLEAN Operation
When the 56℃ Steri-clean function is required,
please access in the hOn APP.
Introduction to Steri Clean
Attention:
1.The function lasts 60-80 minutes.
2.Hot air may come out during the process when evaporator
is heated to 56℃ or maintains at 56℃ in summer.
3.This function may cause changes in room air temperature
in winter.
4.When outdoor ambient temperature is above 36℃, the
function cannot be performed. Instead, Self Clean function
will be turned on and lasts 21mins when Steri Clean is
turned on.
Stage 1 - Self Clean: to remove dirt away this function
freezes the evaporator with moisture in the air, and
removes dirt during the melting process.The hydrophilic
aluminium coating with smaller angel (ɑ≈5°） helps
increase water drainage efficiency.)
Stage 2 - 56℃ high temperature sterilisation: It utilizes
smart temperature monitoring and frequency control
technology to adjust the compressor operation, so that we
maintain the evaporator temperature at high temperature
for over 30mins to kill any bacteria and virus inside the air
conditioner.
Stage 3 - Rapid evaporator cooling to enhance the
sterilisation performance. The foil surface is coated with
silver nano-particles which has an anti-bacterial efficiency
up to 99%.
Press SELF CLEAN button to enter this function. The
display will show "CL" on the panel of the indoor unit and
on the remote controller. Maximum running time in this
function is no more than 21 minutes. This function will exit
automatically with the " Pi " sound twice, then the unit
return to original state.During SELF CLEAN operation,
pressing the button repeatedly will not exit the process.
Press the“power” button to exit this mode.
1.This function is invalid in timer / sleep mode.
,ecuder yam emulov ria eht ,strats edom siht retfA .2
have no airflow, or even cold airflow blowing.
ria eht nehw dnuos emos ekam tinu eht fi lamron si tI .3
expands with heat and contract with cold.
4. The “CL” display time may last dif ferently on the
remote controller and panel.
rorre ,orez woleb si erutarepmet tneibma edistuo eht fI .5
gninaelc-fles gnirud pu wohs eb yam“ 52F“ edoc
operation,which is normal protection, please turn of f the
power and restart after 10 seconds .
eht nehw si ,edom siht nur ot noitidnoc tseb ehT .6
temperature is 20℃~27℃ and the humidity is 35％ 06~
％ indoors, the temperature is 25℃~38℃（ gnilooc
season）outdoors.
7.It is hard for the air to frost if the air is too dry
(humidity＜20%). and if the humidity is too high
(humidity＞70%) the condensate water may increase.
13
To Next Page
Loading...
