Haier AS35TACHRA-TCS - User Manual

Questions and Answers

J
John ColemanAug 9, 2025
Why is my Haier AS35TACHRA-TCS Air Conditioner cooling poorly?
- S
  Sarah PayneAug 9, 2025
  Poor cooling in your Haier Air Conditioner can occur due to several reasons. Check if the air filter is dirty and clean it, normally, every 15 days. Ensure there are no obstacles blocking the air inlet or outlet. Verify that the temperature is set correctly and that all doors and windows are closed. Also, consider whether direct sunlight is entering the room (use curtains) or if there are excessive heat sources or too many people in the room.
S
Sarah RobinsonAug 15, 2025
How to restart Haier Air Conditioner immediately?
- H
  hartmanbrandonAug 15, 2025
  When your Haier Air Conditioner is stopped, it will not restart immediately. There is a 3-minute delay to protect the system. This protection circuit also activates if the electric plug is pulled out and reinserted, ensuring the air conditioner's safety.
J
James Price Jr.Aug 21, 2025
Why is my Haier AS35TACHRA-TCS making noise?
- J
  Joseph CookAug 21, 2025
  Your Haier Air Conditioner may produce a swishing or gurgling noise during operation or when it stops, especially within the first 2-3 minutes after starting, due to refrigerant flowing in the system. A cracking noise during operation is normal, caused by the casing expanding or shrinking with temperature changes. However, if there's a loud noise from airflow, the air filter might be too dirty.
L
Leslie KiddAug 27, 2025
Why does my Haier Air Conditioner smell?
- K
  Kristen RogersAug 27, 2025
  The Haier Air Conditioner might be circulating smells from the indoor environment, such as odors from furniture, paint, or cigarettes.
C
courtneybeckerSep 2, 2025
Why can't I change the fan speed in dry mode on my Haier AS35TACHRA-TCS?
- K
  Kristin SparksSep 2, 2025
  In DRY mode, when the room temperature becomes lower than the set temperature plus 2 degrees Celsius, the Haier unit will run intermittently at LOW speed regardless of the FAN setting.