EasyManua.ls Logo

Haier AU282FHERA - Control Type and Setting Methods

Haier AU282FHERA
146 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
86
74Yhe communication
address between
master5slave wired
controller and the outdoor
is different4
84 Nf central control is
necessary2 all indoor
central control addresses
in one group are identical2
while the indoor address
in different groups is
different too4
HS89
HS87
F2G2H to wired
controller
signal
terminal
block
TKK
TS
HS96
X\6>3_<`
TS
indoor UHG
wired control
master unit
wired control
slave unit
remote control
short connected
short connected short connected
disconnected disconnected
disconnected
blank blank to remote receiver
G2H to wired
controller
F2G2H not to wired
controller
+6+
X\67
_7`3_:`
7{7; .different
dialing setting
on X\67 for
the slave units
in one group
+6+
remarks
Sote@ Nn the above figure2 the state in the frame is set when out of factory4
vs ,A8BBD 7BAFDB? FKC9 E9?97F=BA
X\67
_7`3_:`
74 \hen one wired controller controls one indoor2 multiple
wired controllers control one indoor2 or indoor is controlled
by remote controller2 the switch needs not be changed4
84 \hen one wired controller controls multiple indoors2 the
switch of master unit is 62 while the slave units are at the
position from 7 to 7;4
at +6+
X\68
all at
+TKK+
X\69
74 \hen setting central controlled address by wired controller2
it need not change4
84 \hen setting central controlled address by hand2 refers
to the setting table74
HS8<
HS8;
output in series2 connected to testing device4
HS8=
HS8>
HS89
\hen being controlled by wired controller2 it is connectedA
when being controlled by remote controller2 it is disconnected4
indoor UHG
item
parts state function
dip switch
all at
+TKK+
connected
disconnected
disconnected
disconnected
disconnected
\hen setting communication address between indoor and
outdoor automatically2 it needs not change4 \hen setting by
hand or by wired controller2 refers to the setting table84
connected after being powered on2 indoor JJ[ opens 8
minutes fully4
connected after being powered on2 indoor in time shorting
function
jumper
ws19FF=A; EF5F9 5A8 F<9 :GA7F=BA 89:=A5F=BA B: /|{ 5A8 I=D98 7BAFDB??9D I<9A BGF B: :57FBDK
Jlectric wiring and the application

Related product manuals