49-60796-1
12
REINSTALLATION
1. Remove the lower hinge pin from
the lower hinge by turning counter
clockwise. Move the pin to the
opposite hole and tighten. (see Fig. 6
and Fig. 7)
2. Tilt refrigerator on a 45-degree angle
to have access to the bottom front.
3. Remove both left and right front feet
from bottom.
4. Loosen the screws holding the bottom
hinge and remove it. (see Fig. 7)
5. Align the holes in the bottom hinge
to the corresponding holes on the
opposite side of the cabinet. Insert
and tighten the screws. Reinstall both
front feet.
6. To install refrigerator door: Line up the
left bottom hole of the refrigerator
compartment door over the bottom
hinge pin. Move door forward to make
it straight and align with middle hinge.
Install the middle hinge again, and turn
the hinge pin until it completely enters
the door body. Secure it with the
screws provided. (see Fig. 8)
NOTE: Remove plugs from doorframe
and install on other side.
7. To install freezer door: Line up left
bottom hole of the door over the
middle hinge middle pin. Move door
forward to make it straight and align
with freezer compartment. Place the
hinge cover over the left side of the
top hinge, align holes with hole on the
refrigerator top and tighten with the
screws provided. Insert the top hinge
plug into the holes on the cabinet top
from which you previously removed
the 3 hinge screws
INSTALLATION INSTRUCTIONS
ENGLISH
Bottom
of Unit
Bottom
Hinge
Lower
Hinge Pin
Fig. 6
Fig. 7
Fig. 8
CAUTION
Two People Required
Screw
Holes
Doorstopper
(left side)
Middle Hinge
Pin
Middle Hinge
To Next Page
Loading...
