When the indicator light of the water filter is illuminated this means the water filter should be
changed. After the water filter is changed, please press the water filter reset button M, and the
indicator light of the water filter N will go out.
In the event of an error occurring, the digital display screen will show one of the following
codes: F1, F2, F3, F5, F6, Ed, ER, E0, E1, E2. If this happens, please consult your service
centre to have the refrigerator repaired.
After 30 seconds the digital display on the control panel will switch off until such time as the
refrigerator is used again.
When any door is left open for more than 60 seconds, the door ajar alarm function of the
refrigerator will start, and the alarm will buzz at 30 second intervals to alert the user that there
is a door left open.
This refrigerator is equipped with power-surge protection. When this function is in effect, the
refrigerator will switch off automatically. After 5 minutes, the power should be turned back on.
When the refrigerator turns off as a result of a power surge, the state of the refrigerator before
the power break is memorised, allowing the refrigerator to operate with the programmed
default values prior to the event.
(8) The water filter indicator setting
(9) Control centre power down
(10) Error codes
(11) Door ajar alarm
(12) Over-voltage protection
(13) Power-breaking memorising function
To Next Page
Loading...
