8
Installing the Guardrail
Follow the steps below to install the guardrail on
the worktop.
1. Place the guardrail on top of the cabinet.
2. Align all holes of the guardrail with the holes
of the cabinet.
3. Secure the guardrail to the cabinet with eight
small Phillips-Head screws.
Installation Instructions
Note: Your CO2 cylinder is shipped empty to avoid any possible accidents
during transportation. When you purchase the first keg of beer, have your
CO2 cylinder filled by your local compressed gas supplier. (See Welding
Supply in Yellow Pages)
Tapping the Beer Keg (American Sankey Type Barrel)
Your beer dispenser comes with “Lo-Boy Sankey Coupler American Type.”
This brand name is the most widely used in the United States. Before purchasing
a keg, check with your beer distributor to make sure that an American Sankey
Tap can be used. (Replacement and other taps are available at
www.draughttech.com)
Remove and identify the following components from
the parts box:
1. (1) CO2 Regulator – dual gauge – dual outlet
2. (1) CO2 Tank – 5 pound - EMPTY
3. (2) Keg couplers – low profile type (
Lo-Boy Sankey Coupler
American Type)
4. (4) White plastic squeeze clamps
5. (2) 4 foot long red hose
6. (1) Cleaning kit
BE SURE THAT BEFORE INSTALLATION YOU HAVE FILLED YOUR
TANK WITH GAS
WARNING!
CO2 can be dangerous! CO2 cylinders contain high-pressured gas, which
can be hazardous if handled improperly.
They must be handled with care.
English
English
To Next Page
Loading...
