INSTALLATION INSTRUCTIONS
10
2.Fix the wall hanging brackets to the wall securely (eg. into the stud).
If the studs are too far apart, fit a timber slat to the studs then mount the
brackets onto the slat. The distance between each is 553 mm as per
diagram (Fig.1).
Wood screw
553 mm
3. Install the hooks to the dryer, in the inverted position.
Remove the 2 screws and 2 plastic plugs as indicated in Fig.2.
Fig.1
2 plastic plugs
2 screws
Fig.2
4. Align the hooks as shown in fig.3 and refit screws tightly. Install the
spacers provided in Fig.3.
2 hooks
3 screws
2 spacers
Fig.3
To Next Page
Loading...
