Why is there moisture on the outside of my Haier HF50CW20W?
If you notice moisture forming on the outside of your Haier Freezer cabinet, it's not unusual during periods of high humidity, so you can wipe the surface dry. Also, the lid may not be seating properly, causing cold air from inside the freezer to meet warm moist air from the outside.
Why is my Haier HF50CW20W not running?
If your Haier Freezer isn't running, first, ensure it's properly plugged into a grounded 3-prong outlet. Check the circuit breaker or fuse; reset the breaker or replace the fuse if necessary. Make sure the temperature control is not turned to OFF, and is set between 1 and 7. Finally, the compressor cycle may not be complete, wait 30 to 40 minutes to see whether the freezer will start.
What to do if my Haier HF50CW20W Freezer temperature is too warm?
If the temperature of your Haier Freezer is too warm, there might be several reasons. Check if the lid is left open or if you're opening it too frequently or for too long. Also, make sure the temperature control isn't set too warm and allow several hours for the temperature to stabilize. If you've recently stored large amounts of water or hot food, give the freezer time to reach its selected temperature. Finally, remember that the freezer requires 6-8 hours to cool down completely after being disconnected.
Why are foods defrosting in my Haier HF50CW20W?
If your foods are defrosting in the Haier Freezer, it could be due to a few reasons. Check if the temperature control is set to the OFF position and adjust it to a setting between 1 and 7. Ensure the freezer is properly plugged into the outlet. Also, check the fuse or circuit breaker and replace or reset it if necessary. Make sure the lid is not left open or being opened too frequently or for too long.
Why is my Haier HF50CW20W so noisy?
To address noisy operation or cabinet vibration in your Haier Freezer, ensure the freezer is located on a solid floor. Use shims, as needed, to level the unit. Also, the cabinet should be positioned solidly on the floor. If the freezer is touching the wall, level it or move it slightly.
Why is there so much frost in my Haier HF50CW20W Freezer?
If you observe excessive frost buildup in your Haier Freezer, it may be due to the lid being left open or opened too frequently or for too long. Check to see if a package is holding the lid open and try to open the lid less often. Also, it's not unusual during periods of high humidity, so you can wipe the surface dry.
Why does my Haier HF50CW20W make a popping sound?
If you hear a popping or cracking sound when the compressor comes on in your Haier Freezer, this is normal. It is caused by metal parts undergoing expansion and contraction, as in hot water pipes. The sound will level off or disappear as the freezer continues to run.
What to do if the lid of my Haier HF50CW20W Freezer won’t close?
If you find that your Haier Freezer lid won’t fully close by itself, it's likely that a package is holding the lid open. Try moving the package to a different location.
Why does my Haier Freezer start and stop so often?
If your Haier Freezer is starting and stopping too frequently, it might be because the lid is being left open or opened too frequently or for too long. In that case, check to see if a package is holding the lid open and try to open the lid less often. Also, the temperature control might be set too cold.
How to adjust temperature if food temperature is too cold in Haier Freezer?
If the food in your Haier Freezer is too cold, adjust the temperature control to a less cold setting.
General| Type | Upright Freezer |
|---|---|
| Color | White |
| Defrost Type | Manual |
| Energy Rating | A+ |
| Noise Level | 42 dB |
| Temperature Control | Mechanical |
| Capacity | 50 liters |
To Next Page
