Installation
GB
Notice:
For a free standing appliance: this refrigerating appliance is not intended to be used as
a built-in appliance
Unpacking
▶ Take the appliance out of the packaging.
▶ Remove all packaging materials.
Environmental conditions
The room temperature should always be between 10° C and 38° C, since it can inuence
the temperature inside the appliance and its energy consumption. Do not install the appli-
ance near other heat-emitting appliances (ovens, refrigerators) without isolation.
Space requirement
Required space when door is opened:
W1=905mm
W2=1528 mm
D1=620 mm D4=1024 mm(S Door)
D2=1024 mm /1118 mm(F Door)
D3=1106 mm D5=100 mm
WARNING!
▶ The appliance is heavy. Always handle with at least two persons.
▶ Keep all packaging materials out of children´s reach and dispose them in an environ-
mentally friendly manner.
Ventilaton cross-section
To achieve sucient ventilation of the appliance for
safety reasons, the information of the required ventila-
tion cross sections must be observed.
Aigning the appliance
The appliance should be placed on a flat and solid sur-
face.
1. Tilt the refrigerator slightly backwards.
2. Set the feet to the desired level.
Make sure the distance to the wall on the hinge side is
at least 10 cm for the door to open properly.
1. 2.
40
To Next Page
Loading...
Need help?
General
