12
- There is no sulfur gas or mineral oil existing at the installation place, which may
cause corrosion of the machine and the fittings.
- The water pipe for the water heater used at temperatures below 0°C shall not freeze.
- It shall not be set in rooms where a heating system is used so that heating supply to
the
room will not be affected.
- It shall not be set inside a totally-enclosed space.
- The air taken in must in no event be dusty.
- Install the internal unit in a dry, frost-free room.
- Temperature of the ambient air or of the air taken in by the heat pump for optimum
running: from 10 to 35°C.
- Discharge of condensate:The condensate or water, which is formed in the outdoor
unit
during heating operation, must be eliminated, freely or through the drain. Fix the drain
connection into the hole which is located on the bottom of the unit and connect the
plastic tube with the connector. Ensure that the condensate water runs out in a suitable
drain and make sure the discharge is made without hindrance.
-Keep an adequate distance between the working heat pump and the resting places.
To Next Page
Loading...
Need help?
General
