Installation
Technical data
Removing and installing the doors
In the event that you need to remove the appliance doors, please follow the door removal
and installation instructions below.
1. Undo the hinge cover screw and remove
the cover. Release the cable connector.
2. Undo the screws holding the upper hinge in posi-
tion and then remove the hinge.
3. Lift the freezer compartment door to remove it.
2.
3.
1.
WARNING!
▶ Before any operation, deactivate the appliance and disconnect the mains plug from
the mains socket.
▶ The appliance is heavy. Always handle with at least two persons.
▶ Do not tilt the appliance more than 45° or place it horizontally on the ground
4. Ret the door by reversing the removal steps. En-
sure that the grounding cable will be xed by the
screw.
Notice
The pictures show the removing of the freezer compartment door. For the refrigerator
door please use the corresponding parts on the other site.
Product che according to regulation EU No. 1060/2010
Trade mark Haier
Model identier HRF-521D*6
Category of the model
Refrigerator-freezer
Energy eciency class
A+
Annual energy consumption (kWh/year)
1)
435
Storage volume cooling (L) 341
Storage volume freezing (L) **** 177
Star rating
Temperature of other compartments > 14°C
Non applicaber
Frostfree system
Yes
Temperature rise time (h)
5
Freezing capacity (kg/24h)
12
Climate class
This appliance is intended to be used at an
ambient temperature between 10 °C and
43°C.
SN-N-ST-T
Airborne acoustical noise emissions
(db(A) re 1pW)
43
Construction type
Freestanding
* Color code
1)
based on standard test results for 24 hours. Actual energy consumption will depend on
how the appliance is used and where it is located.
Additional technical data
30
31
Voltage / Frequency 220-240V ~/ 50Hz
Input power (W)
200
Main fuse (A)
15
Coolant R600a
Dimensions (H/W/D in mm)
1790 /908 /655
To Next Page
Loading...
Need help?
General
