Haier HSR3918FI Series - Page 85

EN
10-Installation
35
deriuqer eht htiw seceip owt otni epip eht tuC .1
(B1) and the water tap (B2) (Fig. 10.5-1). Make sure
to get a square cut by using a sharp knife.
esnI .2 rt pipe (B1) approx. 12 mm deep into the
ot gnidrocca )C( pilc gnikcol a htiw epip eht eruceS .3
Fig. 10.5-3.
rehto eht no )2B( epip eht htiw 3 dna 2 pets taepeR .4
oC .5 nnect the end of pipe (B2) to one of the adapters
“D” or “E and F” which suits to the water main (Fig.
10.5-4).
6.
Connect the end of B1 to the valve at the back of
the appliance (Fig. 10.5-6).
7.
Open the water tab to check if the system is leak
WARNING!
8.
Remove the plug in the valve at the back of appliance
(Fig.10.5-5).
Ensure that the connections are always firm, dry and
leak free.
Make sure the hose is never crushed, kinked, or twis-
ted.
▶
▶
10.5-6
B1
B2
A
1/2“
3/2“
D
E
F
10.5-1
ArtNo.601-0010 - S xS 661-9 - Pip e to fil ter
A
B1
10.5-2
ArtNo.601-0005 - SxS 661-9 - S ecur
ing the p
B1
A
C
10.5-3
3/4“ 1/2“
E
F
B2
D
10.5-4
10.5-5
1
2
1
2
1
2