(5) Unit stop
(1) Unit start
Auto,CoolˈDry,Heat and Fan operation
Press ON/OFF button, unit starts.
ON/OFF
FAN
MODE
TIMER
CLOCK
SET
SLEEP
LOCK
RESET
SWING
HEALTH
Operation
mode changes as follows:
(2) Select operation mode
Press MODE button. For each press, operation
Unit will run in selected mode.
(4) FAN
Press FAN button. For each press, fan speed changes
as follows:
AUTO LO MED HI
Unit will run at selected fan speed.
Note:AUTO is not available in FAN mode.
Press ON/OFF button.
Note:
2.In DRY mode, when room temperature becomes lower than temp.setting+2
o
C,
unit will run intermittently at LOW speed regardless of FAN setting.
When FAN is set to AUTO, the air conditioner automatically adjusts the fan
speed according to room temperature.
1.
(3) Select temp. setting
Press TEMP button.
Every time the button is pressed, temp. setting increases 1
o
C
Every time the button is pressed, temp. setting decreases 1
o
C
Unit will start running to reach the temp. setting on LCD.
In FAN operation mode, the unit will not operate in
COOL mode but only in FAN mode ,
AUTO is not available in FAN mode.And temp.setting is disabled.
In FAN mode,SLEEP operation is not available.
3.
8
In HE AT mode, warm air will blow out after a short period
of the time due to cold-draft
prevention function.When FAN is set to AUTO, the air conditioner
automatically adjusts
the fan speed according to room temperature.
4.
just press ON/OFF button and unit will run in previous status.
Remote controller can memorize each operation status. When starting it next time,
5.
Cooling only unit do not have displays and functions related with heating
6.
Operation mode
AUTO
FAN
COOL DRY
Remote controller
Display board
HEAT
To Next Page
Loading...
Need help?
General
