15
On cooling only, heating mode is not available. Remote controller can memorize
each operation status. When starting it next time just press the ON/OFF button
and unit will run in previous status.
Hints
Operation
LO MED HI AUTO
AUTO
COOL operation starts when room
temp is higher than temp setting
Ultra-low air flow
Temp setting
Temp setting+2 C
o
On reaching temp setting unit will
run in mild DRY mode
Unit run at the speed displayed on LCD.
in DRY mode, when room temp. Becomes 2 C
higher than temp; setting, unit will run intermittently
at LO speed regardiess of FAN setting.
o
(3) Fan Speed selection
Press FAN button, For each press, fan speed changes as follows:
16
Operation
(5) Air flow direction adjustment
After operation mode is selected vertical flap will open automatically according to the
mode. Referring to the fig.
Up and down (use remote controller)
Press swing button, vertical flap will move
within the range shown in Fig.
Press SWING button stop it at a
fixed position.
Left and right air flow adjustment
(manual)
Move the horizontal blade by a knob
on air conditioner to adjust left and
right direction referring to Fig.
Cautions:
When humidity is high, condensate
water might occur at air outlet if all
horizontal louvers are adjusted to left
or right.
Cautions:
It is advisable not to keep vertical flab
at downward position for a long time in
COOL or DRY mode, otherwise,
condensate water might occur.
(4)
(5)
o
Low
To Next Page
Loading...
