21
Operation
22
Operation
Emergency operation:
Carry out this operation only when the remote controller
is defective or lost.
When the emergency operation switch is pressed, a "Pi"
sound starts once, which means the start of this operation.
In this operation, it is not possible to change the settings
of temperature and air flow speed, it is also impossible to
do and operation by the timer.
Follow the requirements below.
Emergency operation and test operation
Room
Temperature
Designated
Temperature
Timer
mode
Air flow
speed
Operation
mode
More then 23 C
Less then 23 C
O
O
26 C
O
23 C
O
CONTINUOUS
CONTINUOUS
AUTO
AUTO
HEAT
COOL
If an air conditioner is a model for both cooling and heating.
Cooling when the room temperature at the start of operation is above 23 C.
Heating when the room temperature at the start of operation is less 23 C.
O
O
Room
Temperature
Designated
Temperature
Timer
mode
Air flow
speed
Operation
mode
More then 23 C
Less then 23 C
O
O
26 C
O
23 C
O
CONTINUOUS
CONTINUOUS
AUTO
AUTO
HEAT
COOL
Test operation:
CUse this switch in the test operation when the room
temperature is less 16 C, do not use it in the normal
operation.
Continue to press the test operation switch for more
then 5 seconds. After your hear the "Pi" sound twice,
release your finger from the switch, the cooling operation
switch with the air flow speed setting "Hi".
Removal of the restriction of emergence or test operation:
Press once more the emergency operation switch, or manipulate through the
remote controller, a "Pi" sound causes the restriction of emergency or test operation
to be removed. When the remote controller is manipulate for the removal, then the
selected operation by the remote controller.
To Next Page
Loading...
