11
Operation
Note:
Use two new same-typed batteries
when loading.
If the remote controller con't run
normally or doesn't work at all, use a
sharp pointed item to press the
reset key.
Hints
Remove the batteries in case unit won't
be in usage for long period. If there are
any display after taking-out just need to
press reset key.
Load the battery
Be sure while loading the batteries that
these are in line the "+"/"-" pole request
as illustrated.
Put on the cover again Confirmation
indicator
In disorderation, reload the batteries or
load the new batteries after 5 mins.
12
Operation
Enjoy yourself by just a gentle press.
Auto run, Fan operation
(1) Unit start
Press ON/OFF button, unit starts.
Previous operation status appears on display.
(Not Timer setting)
Power indicator on indoor unit lights up.
AUTO COOL DRY HEAT FAN
LO MED HI AUTO
AUTO
(2) Select operation mode
Press MODE button for each press, operation
mode changes as follows:
(3) FAN
Press FAN button. For each press, fan speed
changes as follows:
Unit will run at selected fan speed.
Note: AUTO is not available in FAN mode.
Adjust air flow direction if necessary, referring to
page 20.
Unit will run in selected mode
Stop display at " " AUTO or " " FAN.
FAN " " AUTO " "
(1)
(2)
(3)
To Next Page
Loading...
