Haier HSW59F18EIMM - Page 18

EN
Use
Filter function
When the refrigerator operates for six months, the reminder indicator “c3” (Filter
Reset function) will light up to remind users to replace with a new lter. When lter is
replaced, hold the button “C” (Filter Reset function selector) for 3 seconds to cancel
the reminder, the timing will reset with buzzer ringing.
Super-Freeze function (Super-Frz)
1. When the display screen is unlocked, press the button “E” (Super-Frz. selector),
the buzzer rings once, the indicator “e1” (Super-Freeze function) illuminates,
and then the Super-Freeze function will be turned on.
2. When the indicator “e1” (Super-Freeze function) illuminates, press the button
“E” (Super-Frz. selector), the buzzer rings once, the indicator “e1” (Super-Freeze
function) goes o, and then the Super-Freeze function will be turned o.
3. After the Super-Freeze function is turned on, the refrigerator will automatically
turn o the function when it reaches the set condition. If you want to exit manu-
ally, you can press the button “E” (Super-Frz. selector) to turn it o.
Indicator off
Press 1 time
Indicator on
Press 1 time
Indicator off
Notice
Under Super-Freeze state, the freezer temperature cannot be adjusted. If either
button “D1” (Temperature adjustment button “-”) or button “D2” (Temperature
adjustment button “+”) is pressed to adjust the temperature of freezer, the indi-
cator “e1” (Super-Frz. indicator) will ash with a prompt sound to indicate that this
operation cannot be carried out.
In the state of Super-Freeze function, the Auto-set function cannot be turned on
at the same time due to dierent control modes. When you choose one function
that conicts with another function, the original function will automatically exit.
Indicator on
Hold for 3s Indicator off
Notice
The normal service life of lter is six months. It is recommended to replace the
lter every six months.
18