10- Installation
GB
10.6 Fine tuning of the doors
If the doors are not in one level, this mismatch can be
remedied by following:
10.6.1 Using adjustable foot
Rotate the adjustable foot according to the direction of
arrow to turn up or down the foot (Fig. 10.6-1).
10.6-1
10.6.2 Using spacers
▶ Open the upper door and lift it.
▶ Carefully clip the spacer (enclosed in the accessory
bag) in the white plastic ring of the middle hinge by
hand or using tools like pliers (Fig. 10.6-2). Do not
scratch or bruise the door.
10.6-2
30
3. The stability can be checked by alternately bump-
ing on the diagonals (Fig. 10.5-3.). The slightly
swaying should be the same in both directions.
Otherwise the frame can warp; possible leaking
door seals are the result. A low tendency to the
rear facilitates the closing of the door.
3.
10.5
Notice: Fine tuning
In the future use of refrigerator, doors uneven phenomenon may occur to the weight of
stored food. Then please adjust according to the above methods.
To Next Page
Loading...
