4
Unpacking Your Wine Cellar
1. Remove all packaging material. This includes the base and all adhesive tape
holding the wine cellar accessories inside and outside.
2. Inspect and remove any remains of packing, tape or printed materials before
powering on the wine cellar.
Leveling your Wine Cellar
• Your wine cellar has 4 leveling legs. After properly placing your wine cellar in
its final position, you can level your wine cellar.
• Leveling legs can be adjusted by turning them counterclockwise to raise your
wine cellar or by turning them clockwise to lower your wine cellar.
Proper Air Circulation
• To assure your wine cellar works at the maximum efficiency it was designed
for, you should install it in a location where there is proper air circulation and
electrical connections.
• The following are recommended clearances around the wine cellar
Sides .....................2" (50mm)
Top .......................4" (100mm)
Back ......................2" (50mm)
• Do not over fill your wine cellar for proper internal air circulation.
NOTE: Allow enough space in the front of the unit to
open the door to 120˚.
English
English
INSTALLING YOUR WINE CELLAR
To Next Page
Loading...
