What to do if my Haier HW50-10F1 Washer does not start?
If your Haier Washer isn't starting, there are several potential causes. First, ensure the machine is properly plugged in. Check your home's fuses and mains power supply. Make sure you've pressed the Start/Pause button. Verify that the program dial is set to the desired position and that the machine door is completely closed.
Why is my Haier Washer not intaking water?
If your Haier Washer isn't intaking water, there might be a few reasons. Check if the water tap is turned on. Inspect the water inlet hose for any twists and untwist it if necessary. Also, the water inlet hose or valve inlet filter could be clogged, so clean them. Finally, ensure the machine door is completely closed.
Guidelines for the proper and intended use of the washing machine for domestic purposes.
Important safety advice and operational precautions to follow before and during machine use.
Critical safety instructions to prevent injuries, risks, and hazards associated with the appliance.
Step-by-step instructions for removing safety screws before initial use to prevent damage.
Guidance on how to level and stabilize the washing machine using its adjustable feet.
Instructions for safely connecting the washing machine to the electrical power supply.
Detailed steps for connecting the water supply hoses to the machine and the tap.
Instructions on how to properly connect the water discharge hose for draining.
Step-by-step guide to starting and operating the washing machine, including selecting programs.
Details for the Cotton 90°C program: temperature, load capacity, duration, and suitable laundry types.
Common causes and solutions for the washing machine failing to start or operate.
Troubleshooting steps for when the machine is not taking in water correctly.
Action to take when the machine displays E01, indicating the door is not closed properly.
Action to take when the machine displays E02, indicating low water pressure or level.
Action to take when the machine displays E03, indicating a pump issue or clogged filter.
Action to take when the machine displays E04, indicating excessive water in the machine.
To Next Page
General
