2
English
Unpacking Your Wine Cellar
1. Remove all packaging material. This includes the foam base and
all adhesive tape holding the wine cellar accessories inside and
outside.
2. Inspect and remove any remains of packing, tape or printed
materials before powering on the wine cellar.
Leveling Your Wine Cellar
• Your wine cellar has leveling feet which are located in the front
and rear corners of your wine cellar. After properly placing your
wine cellar in its final position, you can level your wine cellar.
• The leveling feet can be adjusted by turning them clockwise to
raise your wine cellar or by turning them counterclockwise to lower
your wine cellar. The wine cellar door will close easier when the
leveling feet are extended.
Proper Air Circulation
• To assure your wine cellar works at the maximum efficiency it
was designed for, you should install it in a
location where there is
proper air circulation, plumbing and electrical connections.
• The following are recommended clearances around the wine
cellar:
Sides .......................... 2" (50mm)
Top ............................. 2" (50mm)
Back ........................... 2" (50mm)
• Do not over fill your wine cellar for proper wine cooling.
Note: If your wine cellar has been tilted for any reason, wait 24 hours
before plugging it in.
Installing Your Wine Cellar
To Next Page
Loading...
Need help?
General
