SERVICE MANUAL
Model: WS49GDB
8
Issue 2014-12-10
Rev.
FZ1412S025V3
Chapter 3 Installation, adjustments and maintenance
3-1. Installation
1 Do not install the wine cellar in any location not properly insulated or heated e.g. garage etc, the
wine cellar was not designed to operate in temperature settings below 6 ℃。
2 Select a suitable location for the wine cellar on a hard even surfaces away from direct sunlight or
heat source e.g. radiators, baseboard heaters, cooking appliances etc, Any floor unevenness
should be corrected.
3 To assure the Wine cellar works at the maximum efficiency it was designed for, we should install it
in a location where there is proper air circulation, the following are recommended clearances
around the Wine cellar:
Sides…………..0.8” (20mm)
Top. ……………6.3” (630mm)
Back………….. 4” (100mm)
3-2 Adjustment
3-2-1.Operating the Wine cellar
1 Once the wine cellar is in its proper place, plug it in an electrical outlet having 100~110 volts.
2 Set the temperature, the temperature is adjustable from 6 to 18 . After using the wine cellar for ℃℃
5 hours set the wine cellar to desired setting.
3-2-2. Wine Storage shelves
1 The Freezer has 5 removable even shelves and 1 removable cater-corner shelf. It allows storing
wine more accessibly or can be removed if not needed.
To Next Page
Loading...
