24
Operation
(2) The slave controller cannot set the static pressure function.
(3) You can also use this function by function circulation.
Note: Only valid for the units with self-cleaning function.
(1) Press MENU key, you will enter function circulation, use
or key to switch between dierent functions. When it
switches to the “CL” function, “CL” will ash in the temperature
area. Press MENU key to conrm, and the static display of “CL”
indicates that the function is turned on.
(2) If the state of the “CL” function is on, when you switch to
the “CL” function in the function circulation, pressing MENU
key to turn it o.
(3) When the “CL” function is set, if you switch modes or
switch ON/OFF, the “CL” function will be exit.
(4) If you set timer or sleeping function, “CL” function does not
participate in the function circulation.
If “CL” function is turned on, timer and sleeping cannot be set.
Self-cleaning
To Next Page
Loading...
