Haier YR-E20 - Page 12

11
7. Under O󰀨 state, the clock, ambient temperature (if SW2 is
ON) , timer (if you set) and fresh (only in the case of setting
fresh when wired controller is o󰀨) is displayed ,you can set
clock, timer, fresh, child lock,temperature compensation
paremeter,ambient temperature display under O󰀨 state.
Clock Function
1. Press function key, icon is ashing, then press function
key again,
and the AM or PM are ashing. You can
press up/down key to change the clock. Press function key
to conrm the adjustment. No pressing of function key or
no adjustment for 10 seconds, the clock will back to the
previous station.
2. Press up/down key, the clock will increase or decrease 1
minute once. Keep pressing the up/down key, the clock can
be adjusted more quickly. It will quit the function circulation
after conrm the clock adjustment or no operation for 10
seconds.
3.The clock range: 12:00 AM to 11:59AM(12:00AM is 0 o’clock
in midnight), 12:00PM to 11:59PM (12:00PM is 12:00 at
noon). The default time is 12:00PM.
4. The clock cannot be changed after you set timer/sleeping.
Clock will not in the function cycle after you set timer/
sleeping function.